Siser EasyWeed General Information and Guides
Product Information
Siser EasyWeed (PS Film) heat transfer vinyl is designed for transferring solid colour logos, graphics or text with the advantage of a lower pressure setting for application.
With an adhesive polyester backing, this HTV is thinner than others offering a one-second tack application that is great for multiple layers.
The advantage that it can be peeled hot or cold and does not lift during weeding, this combined with a pressure sensitive carrier that allows you to offer detailed designs on a wide variety of fabrics.
EasyWeed is REACH Compliment and certified Öko-Tex® Standard 100 Class I and is perfect for use on children and baby wear.
Suitable for application onto cotton, polyester, poly/cotton blends and even leather (not suited for treated and dye sublimated textiles).
Product Highlights
- Wide range of colours
- Can be Layered
- Average Thickness 90 microns
Application Instructions
Due to the many different base materials available on the market, these heat transfer instructions are given as a guideline only.

Minimum required pressure: 60gf
- Mirror cut the material
- Weed the exceeding material (for a quick and easier weeding, we suggest to place the cut material for 2 to 3 seconds on a warm surface such as the plates at 60-70°C/140-160°f)
- Place the material on the garment with its polyester backing
- Heat apply design at 150°c/305°f
- Use medium pressure for 15 seconds
- Remove/peel the support carrier warm or cold

Minimum required pressure: 60gf
- Mirror cut the material
- Weed the exceeding material
- Set iron dial between Cotton and Linen
- Cover design with kraft paper or non-stick cover sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 10-15 seconds
- If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
- Remove/peel support carrier hot or cold
Cutting Settings
Please note: The specifications listed are suggested starting points that may need to be adjusted according to blade, cutting strip, and cutting mat wear.

- Blade: AutoBlade, Standard
- Setting: Vinyl +

- Blade: AutoBlade, Fine Point
- Setting: Heat Transfer (Non-Cricut)

- Blade: AutoBlade, 3
- Material: Heat Transfer Smooth
- Force: 6
- Speed: 8

- Blade: Standard, 2
- Cut Speed:
- Cut Pressure: 1

- Blade: AutoBlade
- Cut Speed:
- Half Cut: Auto

- Blade: 45deg
- Gram Force:
- Offset: 250
- Speed: 30-50 cm/s

- Blade: 45deg
- Gram Force:
- Tool: CB09U+0
- Speed: 30-50 cm/s
After Application Care
The following care instructions are suggested as care guidance, always remember to test new products/applications
- Leave to let the adhesive to fully cure for 24 hours before Washing
- Machine wash separately at a maximum of 40°c, inside out
- Dry on a cotton/low heat only, preferably drip dry
- Do not bleach or other aggressive chemical agents / dry clean
- Do not directly iron image, turn the clothing inside out and iron on the reverse
** Please Note: Actual width of Siser EasyWeed is 11.8" +/-, although it is listed as 12" +/- by the manufacture **