
Siser EasyWeed (PS Film) heat transfer vinyl is designed for transferring solid colour logos, graphics or text with the advantage of a lower pressure setting for application.
This HTV is thinner than others offering a one-second tack application that is great for multiple layers .
This vinyl has the advantage that it can be peeled hot or cold and does not lift during weeding, this combined with a pressure sensitive carrier that allows you to offer detailed designs on a wide variety of fabrics.
The Siser EasyWeed is extremely durable wash after wash and is OEKO-TEX class 1 so it's perfect for decorating children's clothing and accessories.
EasyWeed Applies to:
- 100% cotton
- Poly/cotton blends
- 100% polyester
- Leather
- Washing & Care
- Cutter Settings
- Application Guidance
- Wait 24 hours after heat transfer before 1st wash.
- Do not use bleach or other aggressive chemical agents.
- Do not dry clean.
- Machine wash seperately at 40°c/104°f maximum.
- Dry on a cotton cycle or low heat only.
- Do not iron directly on image.
Settings may vary based on blade condition and age of the machine. Always perform a test cut prior to cutting designs.
Cricut:
- Blade: Standard
- Setting: Iron-on
Silhouette Cameo:
- Blade: Standard, 3
- Material: Heat Transfer, Smooth
- Speed: 8
- Force: 6
Scan N Cut:
- Blade: Standard, 2
- Cut Speed: 1
- Cut Pressure: 1
Roland GS/GX-24:
- Blade: 45°
- Gram Force: 80-90
- Offset: .250
- Speed: 25-50 cm/s
Graphtec:
- Blade: 45°
- Gram Force: 8-9
- Tool: CB09U+0
- Speed: 30 cm/s
MH, SC2, LP3, and Titan 1:
- Blade: 45°/60°
- Gram Force: 80-85
- Speed: 300mm/s
- *Blade Advancing Varies
Titan 2 & 3:
- Blade: 45°/60°
- Gram Force: 60-65
- Speed: 300mm/s
- *Blade Advancing Varies
Heat Press:
Vinyl Cutter/Plotter Settings: Blade: new at 45°
Minimum required pressure: 60gf
- Mirror cut the material
- Weed the exceeding material (for a quick and easier weeding, we suggest to place the cut material for 2 to 3 seconds on a warm surface such as the plates at 60-70°C/140-160°f)
- Place the material on the garment with its polyester backing
- Heat apply design at 150°c/305°f
- Use medium pressure for 15 seconds
- Remove/peel the support carrier warm or cold
*Due to the many different base materials available on the market, these heat transfer instructions are given as a guideline only.
Iron:
Vinyl Cutter/Plotter Settings: Blade: new at 45°
Minimum required pressure: 60gf
- Mirror cut the material
- Weed the exceeding material
- Set iron dial between Cotton and Linen
- Cover design with kraft paper or non-stick cover sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 10-15 seconds
- If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
- Remove/peel support carrier hot or cold
*Tests recommended as due to the many different base materials available on the market, these heat transfer instructions are given as a guideline only.
** Please Note: Actual width of Siser EasyWeed is 11.8" +/-, although it is listed as 12" +/- by the manufacture **